|
|
Now that the Diablo is turned over we can start working on the inside. (Below Left) All seams are epoxied before tape and filler are used. This is to prevent the wood from drawing epoxy out of the wood filler and weakening the joint. (Below Right) This picture shows the seam after the filler and glass tape are applied.
We then cut down all frames to proper height. (below Left) We then install the transom support, and knee. (Below Right) We then installed the mid thwart, with a little extra support added to the sides.
In the above right picture, you will notice that we have decided to eliminated the front seating. Instead we opted for storage space. (Below Right and Left) In these pictures you will notice that we installed aft seating supports, as well as the inwales.
|
