|
|
|
(Below Left) Laying the transom and side panel upside down we attach them using nails. (Below Right) We then attach the side panels to the mid and aft supports.
(Below Left) A Spanish windless is used to draw the side panel into the stem. (Below Right) After side panel is nailed and glued into the stem we start fitting the bilge panels into place.
(Below Right) At this stage a two inch wide coating of epoxy is applied to all the seams. (Below Left) Afterwards wood flower is mixed with epoxy to fill any gaps.
(below center) Fiberglass tape covers all the seams, and our boat is ready to be turned over to start the inside.
|
